2023-09-02
松杨电器设备常见的机柜理线方式Cabinet cabling mode
松杨电器设备常见的机柜理线方式
瀑布造型
这是一种古老的布线形状，有时可以看到。它采用了“花果山水帘洞”的艺术形象，双绞线直接从布线架的模块上垂下。分布整齐时，有一种美丽的层次感(每层24-48根双绞线)。
逆向理线
逆向线路是在线路架的模块端连接后，通过测试，然后对机柜进行线路管理。方法是从模块开始向机柜外部线路进行管理，同时在桥架内进行线路管理。这样做的好处是，线路管理在测试后不会因为一根双绞线无法通过测试而重新管理。缺点是两端(进线口和配线架)已经固定，机房某个地方难免会出现大量乱线(一般在机柜底部)。
正向理线
正线是在接线架端之前接线。它从机房的进线口开始，逐段整理电缆，直到接线架的模块处。接线后，进行端接和测试。
Songyang electrical equipment common cabinet wiring method
Waterfall modeling
This is an ancient wiring shape that can sometimes be seen. It adopts the artistic image of "Huaguo Mountain water curtain Cave", and the twisted pair wire hangs directly from the module of the wiring frame. When neatly distributed, there is a beautiful sense of layering (24-48 twisted pairs per layer).
Reverse lineation
After the module end of the line rack is connected, the reverse circuit passes the test, and then the cabinet is managed. The method is to manage the lines outside the cabinet from the module and at the same time manage the lines inside the bridge. The advantage of this is that line management is not remanaged after testing because a twisted pair fails the test. The disadvantage is that both ends (cable inlet and distribution frame) have been fixed, and a large number of chaotic cables (usually at the bottom of the cabinet) will inevitably occur in the equipment room.
Forward lineation
The main wire is connected before the end of the frame. It starts from the inlet of the machine room and arranges the cable segment by segment until it reaches the module of the wiring frame. After wiring, perform termination and test.
